Haltech E6S Manual do Utilizador descarregar pdf (Página 107)

107

excessive (>5 Bar). Running two high current, low impedance injectors from one driver can

result in difficulty in obtaining stable air:fuel ratios when injection times are short (around

idle and light load). The E6S8 model has 4 extra drivers compared to the E6S and should be

used if more than four high current injectors are required.

In general, an injector driver will reliably fire two injectors with more than 2.5 ohms coil

resistance. Coil resistance can be measured with an ordinary low-ohm resistance meter. If you

are unsure which E6S model to choose contact your Haltech dealer for advice.

NOTE: Under no circumstances should you mix saturation and peak-and-hold injectors

on the one driver. This will lead to erratic injector operation.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 133 134

Sem comentários

Haltech E6S Manual do Utilizador Página 107