Haltech E8 Manual do Utilizador descarregar pdf (Página 38)

Haltech E11/E8 Instruction Manual

Ignition Mode Group

• Spark Mode - This mode must be set to the type of ignition system that is to be used on the

engine.

For Piston Engines

Trigger Injection Mode

Standard Trigger Full Cycle, with home on the CAM

24 +1 Multi-Tooth trigger (Honda, Toyota)

Nissan Trigger

Motronic with home signal on the CAM

Subaru

Subaru MY01

Direct Fire Multi Coil

Standard Trigger Full

Standard Trigger Half Cycle with home on the crank

24 +1 Multi-Tooth trigger (Honda, Toyota)

Nissan Trigger

Motronic

Subaru

Subaru MY01

Waste-Spark

All triggers Distributor

For Rotary Engines

Trigger Injection Mode

Standard Trigger with crank home

24 +2 Multi-Tooth trigger

Direct Fire

Wasted Spark Leading ignition

Distributor (with toggle)

Standard Trigger with no home Distributor (without toggle)

Figure 32 - Ignition Trigger Modes

Ignition Spark Edge

The ignition spark edge determines the polarity of the waveform used to drive the ignition module. Falling

edge ignition will use a zero voltage output at idle, a +12V signal for charging, and a falling edge to zero

volts to fire the spark. Most factory ignition systems use falling edge. This is the default setting.

Figure 33 - Ignition Spark Edge Falling

Page: 38

Time

Voltage

Waveform

Naturally Low

Signal Rises to

12V to Charge

Coils

+12V

Note: Take care when setting the ignition spark edge, incorrect settings will damage the

ignition system.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 176 177

Comentários a estes Manuais

Sem comentários

Haltech E8 Manual do Utilizador Página 38

Comentários a estes Manuais

Manuais e produtos relacionados com Para o carro Haltech E8